The stainless steel reaction kettle was used for troubleshooting

　　The stainless steel reaction kettle is used for troubleshooting. The stainless steel reaction kettle will be added to the cauldron in the cauldron at the time of use. What is the effect of this?

　　Reason: to avoid the phenomenon of swirling.

　　When material viscosity is low, high-speed rotating impeller, in under the action of centrifugal force to produce a tangential flow, can make the liquid to the tank wall around, and along the surrounding the kettle, center level natural decline, in stainless steel reaction kettle to form a large recesses, we call this phenomenon for spiral. The swirl material will be followed by the rotation of the agitator shaft. It cannot be well mixed. If polyphase materials are present in the mixing, the phase and phase separation or layering may occur. When the viscosity of the material is high, a large amount of air can be drawn on the surface of the liquid layer to reduce the performance density of the liquid, thus causing the agitating bearing to vibrate with different forces.

　　Stainless steel reaction kettle will produce a lot of problems in work we need to frequent maintenance, routine maintenance also need often explain below small make up for all the stainless steel reaction kettle should be how to work in anti-static. Install electrostatic detente. After the high pressure kettle is in the strainer, the fluid enters the storage tank to install the electrostatic moderator. Avoid mixed water, autoclave medium lose-lose, avoid different medium mixed lose-lose, avoid liquid medium, oil and gas, with compressed air tank to even dehydration, dehydration before pay special attention to feed. Control medium injection mode. The media should be injected from the bottom of the tank to avoid injecting media from the top of the tank. Jumper. The floating roof of the floating roof can be connected to the tank wall. Pipeline and valve, flowmeter, filter, pump, tank used for insulation material or corrosion to cross. Control medium flow rate. The higher the velocity, the more likely it is to generate static electricity. In addition, anti-static additives can be added to the high pressure cauldron, so that the static charge cannot accumulate in the medium, and the earth leakage can be made quickly by grounding the earth.

　　Three points of the high pressure stainless steel reaction kettle:

　　The high pressure stainless steel reaction kettle should be cleaned immediately before cleaning. Now let's take a look at the three main points of attention of the high pressure stainless steel reaction kettle. 1. The reaction solvent is injected into the kettle from the exhaust valve. After cleaning out most of the residue, it is injected into the water for stirring, about 10 minutes before opening the cauldron and cleaning the inner wall of the kettle. 2. When cleaning, it must clean the cauldron and sample valve, while water in the kettle can be filled with nitrogen. 3. The high pressure stainless steel reaction kettle is not used temporarily, so as to add 70% of the clean water ethanol in the reaction kettle, it can not be tightened.